Silicone, adhesive and resin residue remover, available as liquid and aerosol

Adhesive, silicone and resin residue cleaner.

• Excellent dissolving power.
• Easy to apply.
• High effectiveness.
• It leaves no residue.
• Fast evaporation.

Siloclean is a remover of traces of glues, silicones or resins, among others, high-potency, formulated using a synergistic mixture of high-potency, fast-evaporating solvents, wetting agents and adjuvants.

After being applied, Siloclean is absorbed by the layer of glue, silicone or adhesive, dissolving it and/or peeling it off and/or softening it quickly, achieving easy removal of the residue using only a scraper or spatula.

Siloclean is a fast-acting product, allows the removal of silicone residues and resins in a few minutes, an action time that is reduced to seconds when applied to adhesives.

Given its versatility and power, Siloclean is also effective in removing tar stains, permanent marker, candle wax, adhesive tape and superficial grease stains on parts where water-based products cannot be used.

Siloclean is suitable for application on a multitude of surfaces, such as: porcelain stoneware, ceramics, marble, granite, glass, metal… etc. In the case of being applied on plastic, a previous test must be carried out to check the compatibility of the product with the surface.

Fields of application

Siloclean it can be used in all those circumstances in which it is desired to remove traces of silicones, adhesives, resins or tar on mineral surfaces, such as construction supports or glass, or on non-enamelled metal surfaces. Therefore, it is totally suitable for Employment by: marble workers, carpenters, plumbers, sheet metal workers, etc.

How to apply

Siloclean is a ready-to-use product, so it does not have to be diluted before being used. For optimal results, it is recommended to:

• Apply Siloclean directly to the adhesive or residue to be removed, removing as much surface residue as possible by mechanical means (blade, scraper or cutter), if adhesives are to be removed.
• In addition to the above, make crosswise cuts using a blade in the case of removing silicones.

Once this action has been carried out:

• Shake the Siloclean container and apply the product directly to the waste to be removed.
• Leave to act until the softening or dissolution of the residue is observed. As a guideline, the average action time can range from 1 to 10 minutes, depending on the consistency and type of silicone, adhesive, glue or resin to be removed.
• Then, remove the residue with the help of a spatula or absorbent paper.
• Finally, clean the surface carefully with soap and water.

Watch video-demo